The Standard
Assignments
The information in this page is presented to reinforce your understanding of physics concepts directly related to the above standard, and to provide additional resources to further your understanding in the field of waves and optics. As such, not all of the content below is assessed in the exam (some of it's just here to expand your mind!). This is noted in each section.
Wave Parameters (properties) ESA Chapter 5, p47 to 49 - Assessed
Waves are produced by vibrations. A wave acts to transfer energy from one point to another without transferring matter.
The following video provides a concise introduction to wave parameters.
Waves are produced by vibrations. A wave acts to transfer energy from one point to another without transferring matter.
The following video provides a concise introduction to wave parameters.
The Electromagnetic Spectrum - Not assessed
Although not directly assessed in this standard, a basic understanding of the electromagnetic spectrum in a must for any aspiring physics student. The examples discussed in this video are often used as context in exam questions.
Although not directly assessed in this standard, a basic understanding of the electromagnetic spectrum in a must for any aspiring physics student. The examples discussed in this video are often used as context in exam questions.
Diffraction of waves ESA Chapter 5, p55 to 56 - Assessed
Diffraction is the spreading out of waves as they interact with the edges of a barrier or pass through a gap. The level of diffraction we observe depends upon the wavelength of the wave relative to the size of the barrier or gap. This phenomenon is often observed in our daily lives e.g hearing someone around a corner (before you can see them), wave patterns created by rock formations and harbour walls.
Diffraction Video Lesson
It is important to recognise in the diagrams below that the wave remains fundamentally unchanged as it undergoes diffraction. That is, speed, frequency and wavelength do not change (only direction). Your diagrams, in the exam, will need to be accurate enough to show this.
Superposition & Interference ESA Chapter 5, p58 to 61 - Assessed
The principles and concepts of interference apply to both mechanical (water waves, sounds waves etc.) and light waves. The idea being that waves of the same kind can interfere with one another to either increase or decrease amplitude as shown in the diagram below.
The principles and concepts of interference apply to both mechanical (water waves, sounds waves etc.) and light waves. The idea being that waves of the same kind can interfere with one another to either increase or decrease amplitude as shown in the diagram below.
Superposition Video Lesson
Interference Video Lesson
|
The famous Young's Double Slit experiment is explained quite nicely in this video. You can ignore the maths if you wish, as this is Level 3. You need to understand how interference causes the bright/dark fringes and how this relates to path difference (expressed in whole or half wavelengths). Incidentally, this experiment is also used to confirm that light can be both a wave and a particle at the same time!
|
Reflection of Light ESA Chapter 6, p63 to 75 - Assessed
Although plane (flat surface) mirrors are not mentioned in the standard, a sound understanding of 'The Law of Reflection' is a must as it applies to all reflection boundaries (curved or flat).
Although plane (flat surface) mirrors are not mentioned in the standard, a sound understanding of 'The Law of Reflection' is a must as it applies to all reflection boundaries (curved or flat).
Curved mirror Video Lessons
The following set of videos deal with curved mirrors. They are composed by Doc Schuster, a Youtube legend (check out his channel). Some of the terminology and techniques used may vary from what we have done in class - don't let this confuse you.
|
|
|
|
This simulation is great for learning how rays behave with Convex and Concave mirrors and lenses.
|
|
|
Optical Illusions - Not Assessed (would be cool if they were though!)
|
|
Refraction ESA Chapter 7, p77 to 87 - Assessed
The principles and concepts of refraction apply to both mechanical (water waves, sounds waves etc.) and light waves. Refraction occurs due to a change in speed when a wave travels between two different media (substances). If the incident wave strikes the boundary between these media at an angle to the normal, then a change in speed and direction will be observed. Note that speed and wavelength have in inverse relationship and, therefore, frequency remains unchanged.
The principles and concepts of refraction apply to both mechanical (water waves, sounds waves etc.) and light waves. Refraction occurs due to a change in speed when a wave travels between two different media (substances). If the incident wave strikes the boundary between these media at an angle to the normal, then a change in speed and direction will be observed. Note that speed and wavelength have in inverse relationship and, therefore, frequency remains unchanged.
Refraction Video Lesson
Lenses
In this course, you will be asked to solve problems relating to the refraction of light passing through curved lenses. There are two types of lens to cover.
Converging (convex) - light from a source will converge (focus) at a point (focal point) on the far side of the lens.
Diverging lens (concave) - light from a source will diverge on the far side of the lens as if it originated from a focal point on the same side as the source.
Converging (convex) - light from a source will converge (focus) at a point (focal point) on the far side of the lens.
Diverging lens (concave) - light from a source will diverge on the far side of the lens as if it originated from a focal point on the same side as the source.
Lenses video Lessons
The videos below show you how to construct ray diagrams for each type of lens. Note that the terms used are different to what we use in class. All physics principals are the same, however.
|
|
Calculations will involve the use of Snell's Law (see p80 ESA) and Newton's or Descartes' formulas (the same formulas used with mirrors). Refer to your class notes for when to use negative values for virtual measurements, when applying Descartes' formula.
|
|
Total Internal Reflection (TIR) ESA Chapter 7, p81 to 83 - Assessed
If light is travelling from a more dense medium to a less dense medium then the angle of refraction is always greater than the angle of incidence. As the angle of incidence is increased, it follows that the angle of refraction will, eventually, reach 90 degrees i.e. the ray of light will travel along the boundary. The angle of incidence at which this occurs is known as the Critical Angle.
If light is travelling from a more dense medium to a less dense medium then the angle of refraction is always greater than the angle of incidence. As the angle of incidence is increased, it follows that the angle of refraction will, eventually, reach 90 degrees i.e. the ray of light will travel along the boundary. The angle of incidence at which this occurs is known as the Critical Angle.
Total Internal Reflection Video Lesson
Note what happens in the diagram above when the angle of incidence exceeds the critical angle. The boundary now acts to reflect (not refract) the light ray and TIR is observed. Below is a mini-lesson from Kahn Accademy.